Rough Running Over Tampa Bay
Carburetor ice, partial power loss, and a water-surrounded airport — the decision clock is short
The scenario
Departing Albert Whitted Airport (KSPG), St. Petersburg, FL — Runway 07, climbing out over Tampa Bay on a 62° heading. Elevation 7 ft MSL; the runway is essentially at sea level.
It is a hazy Florida afternoon in late spring: OAT 28°C, dew point 22°C, altimeter 29.92. Scattered clouds at 2,500 ft, light rain shower two miles to the northeast. Visibility 8 SM. Classic Gulf Coast conditions — warm, moist, and exactly the environment the FAA icing probability chart marks as 'serious icing at glide power, moderate icing at cruise power.'
You are 400 ft AGL, climbing through 73 KIAS (Vy), heading 062°, when the engine begins to run rough. Power is noticeably down — the tachometer is dropping. The water of Tampa Bay fills the windscreen ahead. KSPG's tower is part-time (0700–2100) and is open; you are in Class D airspace.
Aircraft: Cessna 172N, solo, full fuel, within limits. Carbureted Lycoming O-320, fixed-pitch prop, steam panel, fuel selector on BOTH. Nothing was written up; the airplane was airworthy at departure.
Pilot: you — a Private pilot, current, roughly 200 hours total. You did not apply carburetor heat during the run-up because the engine ran smoothly. You did not apply it after takeoff because you were heads-down on the climb.
- {'label': 'Field', 'value': 'KSPG · Albert Whitted'}
- {'label': 'Runways', 'value': '7/25 · 18/36'}
- {'label': 'Elevation', 'value': '7 ft'}
- {'label': 'Aircraft', 'value': 'C172N'}
- {'label': 'Dominant phase', 'value': 'Landing / Takeoff'}
The decision
Before we get into the decision tree — what do you already know about carburetor ice in the C172N? (Pick all that apply; this records your baseline.)
What the record shows
What the NTSB files show
NTSB CEN24LA362 (2024): A Cessna 172N encountered light rain and carburetor ice at 1,800 ft AGL. The engine ran rough and lost power. The probable cause was carburetor ice formation in conditions conducive to serious icing, with insufficient time and altitude for carburetor heat to clear the accumulated ice. The pilot had not applied carburetor heat proactively in conditions that clearly warranted it.
NTSB CEN14LA276 (2014): A Cessna 172N on a cross-country flight experienced engine roughness and power loss at cruise altitude in conditions conducive to carb icing. The pilot made a forced landing on an island; the aircraft nosed over in soft sand. The pilot survived. The probable cause could not be determined due to premature aircraft release — but the conditions and symptoms are consistent with carburetor ice.
The local environment at KSPG makes this scenario particularly unforgiving: Runway 07's departure end is open water — Tampa Bay. An engine failure on the Runway 07 departure at low altitude is a ditching, not a field landing. There is no open field, no road, no park. The water is the off-field environment. This is not hypothetical; it is the NLCD ground cover off that runway end.
NTSB LAX89LA222 (1989, fatal): A Grumman AA-1C stalled on final approach to a coastal airport after an unstable low-altitude approach in gusting winds. The airplane impacted the water short of the runway. The mechanism — low altitude, low airspeed, pilot trying to stretch the approach to the runway — is the same trap that kills pilots who delay the ditching decision and try to glide to the runway instead.
The real accidents cited above occurred at other airports and in other aircraft — NOT at Albert Whitted Airport. KSPG has its own accident history (see field dominant patterns), but these specific events happened elsewhere. The scenario is localized to KSPG to make the off-field environment real and consequential for you as a student here.
The consistent thread across all these events: carburetor ice in the C172N is insidious. It builds gradually, the first symptom is roughness and a dropping tachometer (not a dramatic power cut), and by the time it is obvious, it may be too late for a comfortable recovery. The fix — full carburetor heat, immediately, at the first sign of roughness in conducive conditions — is simple. The failure is always a delay.
Key lesson — In warm, moist Gulf Coast air, the C172N's carbureted O-320 can accumulate serious carburetor ice even at cruise power and above-freezing temperatures. Apply full carburetor heat at the first sign of engine roughness or unexplained RPM loss. At low altitude over water, the decision window is measured in seconds — not minutes. Off Runway 07 at KSPG, the off-field environment is Tampa Bay: a delayed response means a ditching, not a field landing.
Debrief — teaching points
Carburetor ice forms in conditions you would not expect.
The FAA icing probability chart shows 'serious icing at glide power' at temperatures between roughly 20°C and 30°C when relative humidity is high — exactly the Gulf Coast afternoon conditions at KSPG. You do not need visible ice, freezing temperatures, or IMC. Warm, moist air at reduced power is the classic carb-ice environment. The C172N's Lycoming O-320 is carbureted; it has no alternate air system. Carburetor heat is the only tool.
The first symptom is subtle — a dropping tachometer and engine roughness.
In a fixed-pitch airplane like the C172N, carburetor ice first shows as engine roughness and an unexplained RPM decrease. There is no dramatic power cut. Pilots who are not actively monitoring the tachometer miss the early warning. By the time the roughness is obvious, significant ice has accumulated. Scan the tachometer as part of your regular instrument scan, especially in conducive conditions.
Apply full carburetor heat — not partial — and expect an initial RPM drop.
When you apply carb heat to an iced carburetor, the RPM will drop further before it rises. This is expected and normal: the heat is melting ice and the resulting water is briefly disrupting combustion. Do not remove carb heat when the RPM drops — that is the heat working. Hold it full on. The RPM will recover as the ice clears, typically within 15–30 seconds depending on ice accumulation. Partial carb heat can worsen the situation by partially melting ice into water ingestion without fully clearing the restriction.
At KSPG Runway 07, an engine failure on departure is a ditching.
The off-field environment off Runway 07's departure end (heading 062°) is open water — Tampa Bay. There is no alternate landing surface. If the engine quits on the Runway 07 departure and altitude is insufficient to return to the airport, the outcome is a ditching. This is not a worst-case scenario; it is the geographic reality. Best glide is 65 KIAS. Doors unlatched before water contact. Master off just before impact. Flaps for slowest possible touchdown speed — impact energy rises with the square of touchdown speed, so the slowest possible speed matters most. Know this before you line up on Runway 07.
Proactive carb heat use in conducive conditions is not optional.
The C172N POH and the FAA Pilot's Handbook of Aeronautical Knowledge both recommend applying carburetor heat when conditions are conducive to icing — before the symptom appears. In a Gulf Coast summer departure, with OAT near 28°C and dew point near 22°C, that means applying carb heat during the run-up check (and confirming the expected RPM drop, then recovery) and considering its use during climb in visible moisture or high humidity. Waiting for the roughness to appear at 400 ft AGL over Tampa Bay is waiting too long.
Built from the real accident record
Scenario built from NTSB CEN24LA362 (2024 C172N carburetor ice / power loss), CEN14LA276 (2014 C172N engine roughness / forced landing), ERA09LA517 (2009 C172N total power loss), and local-environment precedents LAX89LA222 and ERA10CA300. Anonymized and localized to KSPG.
NTSB reports: CEN24LA362 · CEN14LA276 · ERA09LA517 · LAX89LA222 · ERA10CA300
ACS tasks: PA.I.F — Weather Information · PA.I.G — Cross-Country Flight Planning · PA.IX.C — Emergency Approach and Landing · PA.I.H — Human Factors · PA.II.B — Engine Starting / Systems Preflight
Relevant FARs: §91.3 · §91.13 · §91.185
Step through the full decision tree, make the calls, and see where each choice leads — then debrief it with your CFI.
Open the interactive scenario →All sample scenarios · More Cessna 172N scenarios · More scenarios at KSPG